Iowa Farm Equipment -- Valby Model CH222 OEM Wood Chipper


\| Home \| Arbor, Forestry & Logging Equipment \| Valby Wood Chippers \| Contact Us \|	We ship nationwide affordably !

Valby Model CH222 OEM
Wood Chipper

A CHIPPER FOR THE FURNITURE INDUSTRY
The CH 222 OEM version of the chipper has a 16" V-belt pulley and a drop chute feed. This model can be used by the furniture industry to dispose of short pieces and other wood residue. The CH 222 OEM also is the right chipper for sawmills, the chipper can chip 18" wide slabs.

POWER REQUIREMENTS
Due to the inertia of the heavy and large rotor, power units down to 35 HP can be used. About 7 HP is required for every inch of round wood diameter. Thus, to chip a 5-inch round wood, you need a 35 HP power unit (7 X 5 = 35).

SAFETY FEATURES
The Valby chippers do not have any knife motion toward the operator-this reduces the risk of loose material flying back through the feed chute.

The knives are counter-sunk into the disk, so the stress of chipping is absorbed by the entire backside of the knife, not just the knife bolts.

The discharge height is 7'11" above ground so the discharge is above eye level. To accomplish safe operation in various wind directions, the Valby chipper's discharge direction is adjustable 360 degrees.

The deflector bonnet enables placing the chips near or far. The Valby chippers also have several noise-reducing features. The discharge opening is above ear level. It is adjustable and can be directed away from the operator.

Valby CH222 with 16" Five Groove Pulley

AVAILABLE FEED CHUTES
The chipper can be used with two types of infeed chutes: the F260 slab chute and the DF230 and DF 232 drop spouts.

The F260 has a control bar that runs on top of the feed chute. The feed can be interrupted by the control bar. The wide feed chute is used for slabs, poles and other materials that need not be compressed.

The DF230 and DF 232 drop spouts are gravity fed, and can be used together with conveyors.

Valby CH222 with Drop Spout and SML 232 Electric Motor Stand

EASE OF OPERATION
The low feeding point ensures effortless feeding of the chipper. The operator can stand with a straight back. The discharge direction is adjustable 360 degrees.

The chipper stands up by itself on the ground and is easy to hook up or remove from the tractor.

SAFETY FEATURES
The Valby chippers do not have any knife motion toward the operator-this reduces the risk of loose material flying back through the feed chute.

CH222HF OEM SPECIFICATIONS
Mounting	3-Point Hitch Cat. I and II
Power Requirements	540 - 1000 RPM; 35 - 60 HP
Tractors with PTO Brake Must Have a Clutch on the PTO Shaft
Chipper Rotor	Diameter: 41-5/16"
	Weight: 488 lbs.
	Knives: Two 11.8" x 5.5" Full-Size Knives
	Infeed Capacity: 9" Diameter Round Wood
	One Anvil
Chip Length	3/4", Not Adjustable
Feed Height	17" Above Ground
Discharge	Adjustable 360^o
	Height: 7'11"
	Height with Optional Extension: 12-1/2'
	Chute Folds for Inside Storage of 87"
CH222 OEM Shipping Weight	1,170 lbs.