Until now, the only tire ballast products available have been expensive foams (which are more sealant than ballast), steel weights and corrosive liquids (like calcium or magnesium chloride). Foams often cost more than the tire itself and ride hard over rough surfaces because the tire is solid. Steel wheel weights are very expensive and cumbersome to mount. And chlorides, while relatively inexpensive, are very damaging to wheel rims, equipment and the environment.
This 8-year-old rim came from a tubed tire with calcium chloride ballast.
Rim Guard is the superior tire ballast because it's...
- Non-corrosive to metal.
- Non-toxic to humans and animals.
- Environmentally safe & biodegradable.
- Freeze-rated to -35°F.
- A ready-to-use liquid.
- Non-abrasive to metal, rubber, plastic, and other materials.
- Much less expensive than iron weights.
- Great for tractors, loaders, skid steers and more.
Rim Guard™ also...
- Weighs just about the same as Calcium Chloride (10.7-11 lbs. per gallon).
- Allows for lower center of gravity, more stability & increased pulling power.
- Can be used with tubed as well as tubeless tires.
- Is made from an agricultural byproduct of sugar beet processing. It comes from the farm and goes back to the farm.
Your cattle want to know...
Why aren't you using Rim Guard™? After all, it's environmentally safe and biodegradable – and it eliminates the worry that a tire puncture will contaminate your (their) field
Well, all of that has changed. Now there is a new product for tires called Rim Guard™, a patented liquid wheel ballast that eliminates rust damage to tire rims, valves, gauges and pumps. In fact, Rim Guard™ is specially formulated to protect metal from damaging corrosion. Rim Guard is so safe it's even OSHA-approved for use as livestock feed. Best of all, this amazing product is easily injected into tires or tubes and can be used safely in both new and antique equipment.
Rim Guard™ is perfect for use with:
- Farm tractors (both modern and antique).
- Small tractors with front-end loaders.
- Commercial backhoes, bobcats and all-terrain forklifts
- Road graders and all types of lawn & garden tractors.
Compare the advantages of Rim Guard™ over all other tire ballast alternatives.
- Iron weights cost about $1-$2/lb. Rim Guard™ costs about $.28/lb.
- Iron weights often load axles, frames and extend turning radius when mounted on the nose. Rim Guard™ puts the weight where you need it – at the point where the rear tires contact the ground.
- Unlike Iron Weights, Rim Guard™ doesn’t change the turning radius or occupy the 3 pt. hitch.
- Unlike Iron Weights, Rim Guard™ can be installed in front tires to help balance vehicle weight and improve traction of 4WD tractors.
- Calcium Chloride seems inexpensive until you account for the fact that it should be contained in a tube. This adds cost ($39-$80 per tube) plus labor to tear down a tubeless tire and install the tube. Rim Guard™ comes ready-to-use and can be installed in both tubed and tubeless tires.
- Calcium Chloride is heavy – about 11.5 lbs./gallon. Rim Guard™ weights 10.7-11 lbs. per gallon – about the same.
- Calcium Chloride is freeze resistant to -30°F or -40°F depending upon how it is mixed. Rim Guard™ is freeze resistant to -35°F and will not solidify until -50°F.
- Calcium Chloride is highly corrosive. It will corrode/rust rims, valve stems, pumps, hose fittings, and shop tools. Rim Guard™ is non-toxic, non-corrosive, and biodegradable.
- Over time, if Calcium or Magnesium Chloride leaks from a tube, it will destroy the rim and valve stem. It will ruin the clothes of those who handle it and burn their hands. Rim Guard™ is totally non-corrosive. It will never rust a rim or valve stem. It is water soluble – easily rinses with water from hands and clothing.
- Calcium Chloride is toxic. It will contaminate soil and prevent plants from growing if it spills. Many states and municipalities classified it as a hazardous waste requiring cumbersome and expensive handling and disposal procedures. Rim Guard™ is totally non-toxic, biodegradable, and animal food safe. It is easily diluted with water and can be disposed of as easily as water.
- Calcium Chloride often must be mixed from powdered salt. Rim Guard™ comes ready-to-use. No mixing is required.
- With Calcium Chloride-ballasted tires, minor punctures are very expensive to repair. First, the liquid must be pumped from the tire, the tire broken down, and the tube removed and patched. The rim should be thoroughly cleaned of any calcium chloride residue to prevent rust. Then the tire must be reassembled and refilled with ballast. With Rim Guard in a tubeless tire,you simply rotate the puncture to the top and plug it like you would a car tire – and you're done!
Anti-Freeze or Glycol
- Automotive anti-freeze is highly toxic. It will contaminate soil and pollute ground water. It will poison animals. And it requires special disposal methods. Rim Guard™ is a byproduct of sugar beet processing. It comes from the farm and returns to the farm. It is non-toxic and can be diluted with water and rinsed down the drain if it spills.
- Anti-freeze is no heavier than water – about 8.3 lbs./gallon. Rim Guard™ weighs 10.7-11 lbs./gallon – 30% heavier by volume.
- Anti-freeze or glycol is non-corrosive and is freeze resistant to about -25°F depending upon how it is mixed. Rim Guard™ is non-corrosive and freeze resistant to -35°F.
- Anti-freeze usually costs more than Rim Guard™, especially per pound of weight.
Methanol and Water
- Methanol is highly flammable! Careful handling is required, and it should be mixed with water. Rim Guard™ is non-flammable and comes ready to use!
- Methanol weighs less than plain water and is therefore a poor alternative to Rim Guard™.
- Methanol is very toxic and will attack certain rubber compounds over time. Rim Guard™ has no ill effects on rubber or metal.
- While Methanol is generally non-corrosive and will not freeze down to about -10°F to -20°F while Rim Guard™ is freeze-rated to -35°F.
Windshield Washer Solvent
- Windshield Washer Solvent is no heavier than water. Rim Guard™ is 30% heavier than water.
- It usually is non-corrosive and non-flammable but is somewhat toxic. It's certainly not animal-safe. Rim Guard™ is so safe it's even OSHA-approved for use as livestock feed.
- Windshield Washer Solvent is about the same cost as Rim Guard™, but more expensive when you consider it as a cost per pound.
- Windshield Washer Solvent is freeze resistant only to -20°F. Rim Guard™ is freeze-rated to -35°F.
- If you are paying for weight, Windshield Washer Solvent is a poor alternative because Rim Guard™ is heavier, non-toxic and often about the same price.
How much weight will Rim Guard add to my tractor?
Rim Guard weighs about 10.7 to 11.0 lbs. per gallon. Usually, tires are filled to the 12:00 rim position or about 75% full. The actual weight is a function of tire size. Both front and rear tires can hold liquid ballast. Refer to the tire hydro-flation tables in the Documentation section to select your tire size, gallons of Rim Guard™ required to fill the tire and the resulting weight added to the tire.
What happens if I get a puncture?
Most minor punctures in tubeless tires can be fixed by plugging the hole just like a car tire. First, rotate the hole to the top and remove the object that caused the puncture. Next, follow the instructions on the plug kit. Do not continue to operate the tractor on a soft tire. You will risk breaking the bead away from the rim and losing all of the Rim Guard™.
Rim Guard™ does not require tubes in the tires. What if I already have tubes in my tires?
Rim Guard™ can be used with or without tubes. There are no disadvantages to tubes other than the repair cost of a minor puncture. In this case, the liquid ballast must be pumped out of the tube, the tube removed from the tire, patched and perhaps booted, and then the entire tire must be reassembled and refilled with ballast. Repair cost is high, but there is little risk of losing ballast from a leak, and there’s no need to clean the rim as you would with calcium chloride.
Are there any disadvantages to Rim Guard™?
Absolutely none. Rim Guard™ will prevent rim corrosion for the life of the tractor and it is environmentally friendly – more so than any other liquid ballast.
Do I have to fill the tire 75-80% full?
No, any amount of Rim Guard™ will protect the rim from rusting. However, filling the tire 75-80% will optimize pulling power and, just as importantly, lower the center of gravity and increase the overall stability of the piece of equipment.